ST3500418AS 9SL142-301 CC37 2364 L 100532367 REV A 3.5'' SATA Seagate circuit board replacement +FW

Hard Drive Circuit Board for Data Recovery

This PCB (circuit board,donor board,controller board) is intended for individuals attempting data recovery on their hard drive. It comes with a fully tested PCB and a full set of instructions.This item is intended for you to diagnose if your hard drive has a circuit board problem, and if it does, recover your valuable data.

Compatibility info:

Model : ST3500418AS

Board Number: 100532367 or 100535704

1. As long as your Board Number is 100532367 or 100535704 , our board is same as yours in hardware

2. For this model hard drive(even identical from outside),every PCB BIOS IC is different from each other. The BIOS IC swap is a MUST !!!

• BIOS IC Swap
  You should swap the BIOS IC before you swap the PCB, in order to make the replacement board compatible with your Hard Drive.
  We swap the BIOS IC for our clients for free, but we need you to ship your board to us.
• If you do not want us to swap the BIOS IC
  please email us to let us know, otherwise we will wait for your board to come to us.
• Email : hddparts@gmail.com

Procedure
1. buy the board, fill the form and ship your board to us(clients pay the shipping fee to us)
2. we swap the BIOS IC, and ship back to you(we offer free shipping to clients)
3. If you do not want us to swap the BIOS IC, we ship the donor board to you.
4. customs declare as: bad hard drive board for repair, value:$10.00

• Support: hddparts@gmail.com

When to Buy This Item?

1. You are very positive the PCB is dead
2. There is obvious damage on the PCB board
3. The hard drive does not spin (the hard drive never fell or was shaken)
4. If the hard drive simply can't be detected, or if it is clicking, then it could be a circuit board problem, but it could easily be internal damage as well. It is often a gamble in this case.

Please note that this item can fix drives with ONLY circuit board problems. Some drives have internal damages that can't be detected easily. Please do NOT attempt to open the drive without a clean room. There is no return policy for this item.

Seagate "firmware bricked" problem?

1. The hard drive runs fine (no clicking sound or noises, errors etc), but can't be detected by the computer
2. The hard drive runs fine but the size is 0MBs
3. Drive reports SMART errors on boot

To fix Seagate  "firmware bricked" problem: Please check the item to fix firmware brick

Note: Before purchasing, please read:
1. This is just a PCB (Printed Circuit Boards), not the whole Hard Drive;
2. It is used as data recovery/repair issues, there is no refund/exchange policy;
3. It is a buyer responsibility to know if the board is adequate for his hard drive model;
4. Hard drive failures are NOT always caused by PCB failure. We cannot guarantee your
drive to be repaired by replacing the PCB;
The estimate shipping time and cost
Our Clients enjoy FREE shipping(from us to clients), Item will be shipped by Canada Post
Light Packet (No tracking number). The estimate delivery time :

Our shipping address:
DataPro Data Recovery Lab
# 528 - 15216 North Bluff Road
White Rock BC
V4B 0A7
Canada
1-888-688-5588